TSS_Covers

All covers are raw unpainted black resin with a matte surface finish. You can sand, buff & polish the parts if you would like a shinier finish

All covers come with the following:

  • Pre-set heat inserts to mount the cover to your grill
  • 2x M3 bolts
  • 2x M3 lock washers
  • 2x flat washers
  • pre-installed 3m tape
  1. Version 1 – Grill Garnish for TSS sensor 

    * This is the version to select if you have a TSS sensor. This has a protrusion area for the sensor to ensure it does not cause issues.

    !*!*!DISCALIMER!*!*!
    For V1 (for the TSS Sensor cover) 
    This product is an aftermarket,  intended for off-road, show, or experimental use only. While it has been tested on a personal vehicle without observed issues; vehicle systems, sensors, and operating conditions vary. Installation and use of this product are performed at the customer’s own risk. The seller makes no guarantees regarding compatibility, performance, or long-term effects on vehicle components and assumes no responsibility for damage, malfunction, injury, or loss resulting from the use, misuse, or installation of this product. By purchasing and installing this product, the customer agrees to release the seller from any and all liability to the fullest extent permitted by law.  
  2. Version 2 – Grill Garnish – Backing (No TSS Sensor)

    * This is an alternate version of the grill cover for those who DO NOT have a TSS sensor, this is a full backed piece that covers the TSS mount/grill area
  3. Version 3 – Grill Garnish – No backing (No TSS sensor)

    *This is an alternate version of the grill cover for those who DO NOT have a TSS sensor
          *   For a better esthetic, cutting the mount areas for the TSS sensor off your grill is recommended for this version as the mount /support areas for the TSS sensor in your grill will show through. 
    Recommended areas to cut out highlighted in Yellow, Purple highlight is the TSS sensor on my truck but since you are selecting V3 you do not have a TSS sensor. (This is a prototype of v3 that was 3d printed not to reflect production quality of the part you will receive.)
Scroll to Top